Single chip 76-to-81GHz mmWave sensor
30th August 2018
Source:
Texas Instruments
.jpg)
The IWR1642BOOST from Texas Instruments is an easy-to-use evaluation board for the IWR1642 mmWave sensor, with direct connectivity to the microcontroller (MCU) LaunchPad Development Kit. The BoosterPack contains everything required to start developing software for on-chip C67x DSP core and low-power ARM R4F controllers.
This includes onboard emulation for programming and debugging, as well as onboard buttons and LEDs for quick integration of a simple user interface.
A 5V 2.5A supply brick with a 2.1mm barrel plug (center positive) is not included. TI recommends purchasing an external power supply that complies with applicable regional safety standards.
Features
- Onboard antenna to enable field testing
- XDS110-based JTAG with serial port interface for flash programming
- UART-to-USB interface for control, configuration, and data visualization
- TI LaunchPad interface to seamlessly connect to TI MCUs
- CAN connector enables direct interface to car units
To find out more information, click here.
Similar articles
More from Texas Instruments
- Single-chip automotive radar sensor integrating DSP 7th November 2018
- Isolated CAN FD transceivers deliver high bus fault protection 1st November 2018
- Taking charge of electric vehicles 17th October 2018
- High voltage and isolation leakage measurements reference design 15th October 2018
Product Centre Updates
Ceramics Expo 2019
29th April 2019
United States of America International Exposition Center (I-X Center)
Write a comment
No comments