Electric vehicle testing on show at Automotive Testing Expo

21st September 2017
Posted By : Lanna Cooper
Electric vehicle testing on show at Automotive Testing Expo

 

Manufacturer of high performance dynamometer systems, SAKOR Technologies has announced that it will be exhibiting at the Automotive Testing Expo North America, 24th-26th October 2017 at the Suburban Collection Showplace in Novi, Michigan.

SAKOR will be highlighting many of their technologies at Booth 10009, including hybrid and electric vehicle testing, high voltage battery testing and simulation, and the smallest AC regenerative engine dynamometer available in the industry.

SAKOR technical experts will be on hand at the booth to offer expertise and answer questions about their products.

SAKOR has extensive experience in electric motor and generator testing, as well as engine and powertrain testing. The DynoLAB Test Cell Control System being highlighted can perform a wide variety of road load profiles and simulations, and is designed for testing to all international standards, including existing and proposed EPA, CARB, and Euro standards.

The high voltage battery simulator/testing system is suitable for customers conducting research and development, performance evaluation, and durability testing of high voltage DC power systems. It can be used for testing high voltage batteries as well as simulating high voltage batteries while testing hybrid and electric vehicle drive lines and inverter systems.

The high voltage battery simulator/testing system is fully line regenerative, resulting in a very power efficient unit, minimising electricity usage, lowering operating costs, and providing an extremely environmentally friendly 'green' profile.

The small engine AC motoring dynamometer on display is the smallest available on the market today. Featuring ultra low inertia properties, the unit can convert easily between horizontal and vertical orientations, accommodating either shaft orientation. It was developed specifically to meet the needs of small engine manufacturers who must comply with engine testing procedures required by 40 CFR Part 1065 emission standards.

This machine can test both steady state and transient emissions cycles, and allows users to avoid the issues associated with larger dynamometers, such as breaking of drive-shafts or couplings.


You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

ELIV 2017
18th October 2017
Germany Bonn World Conference Center
TU-Automotive Europe 2017
6th November 2017
Germany Munich
Smart Mobility Executive Forum
12th February 2018
Germany Berlin